40 lines
1.5 KiB
Plaintext
40 lines
1.5 KiB
Plaintext
= Attaching a 16x2 LCD via I2C
|
|
|
|
This example code shows how to interface the Raspberry Pi Pico to one of the very common 16x2 LCD character displays. The display will need a 3.3V I2C adapter board as this example uses I2C for communications.
|
|
|
|
[NOTE]
|
|
======
|
|
These LCD displays can also be driven directly using GPIO without the use of an adapter board. That is beyond the scope of this example.
|
|
======
|
|
|
|
== Wiring information
|
|
|
|
Wiring up the device requires 4 jumpers, to connect VCC (3.3v), GND, SDA and SCL. The example here uses I2C port 0, which is assigned to GPIO 4 (SDA) and 5 (SCL) in software. Power is supplied from the 3.3V pin.
|
|
|
|
WARNING: Many displays of this type are 5v. If you wish to use a 5v display you will need to use level shifters on the SDA and SCL lines to convert from the 3.3V used by the RP2040. Whilst a 5v display will just about work at 3.3v, the display will be dim.
|
|
|
|
|
|
[[lcd_1602_i2c_wiring]]
|
|
[pdfwidth=75%]
|
|
.Wiring Diagram for LCD1602A LCD with I2C bridge.
|
|
image::lcd_1602_i2c_bb.png[]
|
|
|
|
== List of Files
|
|
|
|
CMakeLists.txt:: CMake file to incorporate the example in to the examples build tree.
|
|
lcd_1602_i2c.c:: The example code.
|
|
|
|
== Bill of Materials
|
|
|
|
.A list of materials required for the example
|
|
[[lcd_1602_i2c-bom-table]]
|
|
[cols=3]
|
|
|===
|
|
| *Item* | *Quantity* | Details
|
|
| Breadboard | 1 | generic part
|
|
| Raspberry Pi Pico | 1 | https://www.raspberrypi.com/products/raspberry-pi-pico/
|
|
| 1602A based LCD panel 3.3v | 1 | generic part
|
|
| 1602A to I2C bridge device 3.3v | 1 | generic part
|
|
| M/M Jumper wires | 4 | generic part
|
|
|===
|